Use an ABC type dry chemical fire extinguisher.Wear a respirator, eye protection, and rubber gloves where appropriate.Disconnect the battery from the system.Use only approved battery chargers for charging the battery.Do not install the battery in a location that may be flooded.Do not install the battery if there are any signs of physical damage. ![]() Electrical and shock hazards can be minimized by covering the solar array and using insulated tools.The battery should only be installed in locations approved by local building codes.The battery should be installed as per national and local codes.Failure to follow these safety instructions may result in electrical shock, injury, or death, or may damage the battery or other equipment or property. While LiFePO4 batteries are inherently safe, as with all batteries, energy storage devices, and electrical equipment, safety, and electrical hazards do exist. 2 below demonstrates proper and improper connections. Failure to adequately secure connections can result in severe damage and will void your warranty. Use a torque wrench to torque your hardware to the specification of 9 to 11 ft-lbs. When connecting to your battery terminals, DO NOT finger tighten.If multiple lugs are used, they should be on the same side of the terminal. When going from left to right in the diagram the correct order is bolt, washer, lug, terminal, washer, and nut. 1.įigure 1: Proper order of hardware to connect cables. The proper order to connect to your terminal with a finishing kit is shown in Fig. Make sure to connect your positive load specified cable lug to the positive terminal and the negative load specified cable lug to the negative terminal. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |